Come PDF Online

Best Stainless offers high quality standards including UNS S, AMS , ASTM A, and ASTM A Grade PH stainless steel can be used. This standard is issued under the fixed designation A /A M; the number . [ mm] round bar, 10 to 12 ft [ to m] in length, ASTM A See the chemical composition and physical properties of ASTM A Grade condition HM, find alternative materials, and connect with suppliers.

Author: Shaktilabar Dizil
Country: Morocco
Language: English (Spanish)
Genre: Career
Published (Last): 17 December 2015
Pages: 376
PDF File Size: 17.6 Mb
ePub File Size: 13.34 Mb
ISBN: 420-3-69839-772-5
Downloads: 93536
Price: Free* [*Free Regsitration Required]
Uploader: Shakajar

ASTM A 564

Active view current version of standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.

The material shall be subjected to tension, impact, and hardness tests. I Refer to Table 2 for details on equalize and over temper heat treatment. A 87 [] 58 [] This standard has been approved for use by agencies of the Department of Defense. Hot-finished or cold-finished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included; these shapes may be produced by hot rolling, extruding, or forging.

  BAFIN MARISK PDF

F Maximum ksi [ MPa] tensile strength only for sizes up to 12 in.

D BH for rounds cold drawn after solution treating. Such requirements may include but are not limited awtm the following: ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. NOTE 3—A typical ordering description is as follows: Active view current version of standard. Hot-finished a54 cold-finished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included.

CW 12 hard CW full hard 7. TypesXM, and XM may be furnished in the solution-annealed or age-hardened condition.

T – Transverse axis of specimen perpendicular to direction of grain ow during rolling or forging. Current edition approved May 1, Combining values from the two systems may asmt in nonconformance with the specification. Up to 12 in. Type XM is machinable in the as-received fully heat treated condition.

The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Hold for not less than 3 h. C Unless otherwise noted, temperatures shown are suggested temperatures and may be varied to obtain required tensile properties.

  KOUTSOYIANNIS A.MICROECONOMA MODERNA PDF

ASTM A – Martensitic Stainless Steel

Combining values from the x564 systems may result in nonconformance with the specification. Billets or bars for reforging may be purchased to this specification.

Type UNS S is suitable for machining in the solution-annealed, cold-worked, and aged-hardened condition. Historical Version s – view previous versions of standard.

The values stated in each aetm are not exact equivalents; therefore, each system must be used independent of the other. Work Item s – proposed revisions of this standard. Type UNS S shall be furnished in solution annealed, cold-worked or aged-hardened condition.

Link to Active This link will always route to the current Active version of the standard.

Hot-nished or cold-nished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included; these shapes may qstm produced by hot rolling, extruding, or forging. A superscript epsilon indicates an editorial change since the last revision or reapproval. Note 2 — For billets and bars for forging see Specification A